1602 Chappell Dr
In Compliance
No violations were found at the most recent inspection.
Source: the Saskatchewan Health Authority
This restaurant has been inspected 3 times since March 14, 2025, with 1 in-compliance result, 2 not-in-compliance results, and 0 closures on record.
No violations
1 violation
Mechanical Dishwashing: Chlorine sanitizing solution is not at least 100 parts per million at 24°C - 44°C (75°F - 111°F). Refer to 3.1.c.ii of the Public Eating Establishment Standard.
This record comes from the Saskatchewan Health Authority, via the provincial Inspection InSite portal. Inspectors record any violations of applicable health regulations on each visit. The result above is the most recent inspection on file.
SK inspections are recorded as In Compliance, Not in Compliance, or Closed. In Compliance means no violations were cited on the visit. Not in Compliance means issues were found and the operator must correct them, with a re-inspection scheduled. A closed order means the inspector required the place to stop serving customers until the issues were corrected.
5 violations
Mechanical Dishwashing: Chlorine sanitizing solution is not at least 100 parts per million at 24°C - 44°C (75°F - 111°F). Refer to 3.1.c.ii of the Public Eating Establishment Standard.
Food Protection: Food and water is not protected against potential contamination. Refer to section 20 of The Food Safety Regulations.
Temperature Control - Cooking, Reheating and Hot Holding: Potentially hazardous food is not kept at an internal temperature of 60°C (140°F) or greater for hot holding. Refer to clause 23(1)(a) of The Food Safety Regulations.
Maintenance & General Sanitation: Utensils as specified by the Public Health Inspector, are not kept clean and sanitized and/or maintained in good repair. Refer to 3.1.5 of the Public Eating Establishment Standards.
Maintenance & General Sanitation: Equipment as specified by the Public Health Inspector, are not kept clean and sanitized and/or maintained in good repair. Refer to 3.1.5 of the Public Eating Establishment Standards.