150 - 6424 36 Street NE
Non conforme
12 infractions relevées lors de la dernière inspection.
Source : Alberta Health Services Environmental Public Health
7 août 2026
There was no sanitizer prepared., , 100 ppm chlorine sanitizer was prepared during the inspection. Prepare an approved sanitizer before handling food.
A spray bottle that contained soap was incorrectly labeled as Windex., , The operator voluntarily discarded the spray bottle. Ensure chemical bottles are accurately labeled to indicate their contents.
Knives, drain plugs, equipment parts and a sharpening steel were observed in the hand sink located by the 2-compartment sink., , Items in the hand sink were removed during the inspection. Ensure hand sinks are accessible at all times.
A cell phone was observed on a meat cutting table., , The cell phone was removed from the food handling area during the inspection. Keep personal items separately.
Weather stripping on the bay door across from the walk-in freezer was in a state of disrepair, leaving visible gaps at the bottom of the door., , Replace weather stripping to avoid the entry of pest.
Mouse droppings were observed in the bay/loading area in front of the walk-in freezer., , Remove mouse droppings safely and disinfect contaminated areas. Seal possible pest entry points and remove clutter in this area.
The leather chair by the display case was damaged with foam exposed., , Remove this leather chair. A chair that is in good condition and can be easily cleaned can be used.
The bay/loading area had holes in the floor with an accumulation of concrete fragments and splinters., , Repair the floor so that it is smooth, non-absorbent to moisture and easy to clean.
Metal floor-wall joints in the food processing area and walk-in coolers were covered in rust., , Remove rust, repair or replace the metal joints.
1) Shelves in the small walk-in cooler were rusty. , , Repair or replace shelves., , 2) There was a hole under the hand sink located by the display case., , Repair the wall., , 3) Water had accumulated on the damaged flooring located by the band saw., , Repair the floor., , 4) There was a gap between the wall and metal floor-wall joints in the large walk-in cooler., , Seal gaps., , 5) The floor in the back meat processing area was in a state of disrepair. Water had accumulated on uneven surfaces. , , Repair the floor.
There was old food debris in the hard-to-reach areas of the food slicer., , Disassemble equipment to its simplest form. Clean and sanitize all parts properly after use.
1) Water was dripping from the condenser in the small walk-in cooler. The floor was wet., , Repair the walk-in cooler to stop the leak and clean the floor., , 2) The 3-compartment sink for the retail was not usable due to a missing faucet handle. , , Repair the sink., , 3) The door for the walk-in freezer did not seal properly. Water was dripping from a hose outside of this door. Water on the floor had froze. , , The hose was properly turned off during the inspection. Repair the door and remove ice from the floor., , 4) There was a buildup of ice in the corner of the large walk-in cooler., , Remove the source of ice build-up and remove ice from the floor.
Cadalow Halal Meat se trouve dans le quartier WESTWINDS. WESTWINDS, Calgary compte 249 restaurants suivis sur Pass or Fail, inspectés par Alberta Health Services Environmental Public Health. En date du 20 août 2026, 173 (69%) d'entre eux étaient Conformes lors de leur dernière inspection, sans Non conforme ni fermeture.
Ce dossier provient d'Alberta Health Services Environmental Public Health, qui inspecte les établissements alimentaires partout en Alberta. Les inspecteurs notent toute infraction aux règlements sanitaires applicables à chaque visite. Le résultat ci-dessus correspond à la dernière inspection au dossier.
« Conforme » signifie qu'aucune infraction n'était en suspens lors de cette visite. « Non conforme » signifie qu'une ou plusieurs infractions n'ont pas été corrigées sur place. « Fermé » signifie que l'inspecteur a ordonné l'arrêt du service à la clientèle jusqu'à la correction des problèmes.
Shambhus Coffee Bar
SADDLE RIDGE INDUSTRIAL
Ce restaurant a été inspecté 10 fois depuis le 23 avril 2024, avec 1 conforme, 9 non conformes et 1 fermeture au dossier.
12 infractions
There was no sanitizer prepared., , 100 ppm chlorine sanitizer was prepared during the inspection. Prepare an approved sanitizer before handling food.
A spray bottle that contained soap was incorrectly labeled as Windex., , The operator voluntarily discarded the spray bottle. Ensure chemical bottles are accurately labeled to indicate their contents.
Knives, drain plugs, equipment parts and a sharpening steel were observed in the hand sink located by the 2-compartment sink., , Items in the hand sink were removed during the inspection. Ensure hand sinks are accessible at all times.
A cell phone was observed on a meat cutting table., , The cell phone was removed from the food handling area during the inspection. Keep personal items separately.
Weather stripping on the bay door across from the walk-in freezer was in a state of disrepair, leaving visible gaps at the bottom of the door., , Replace weather stripping to avoid the entry of pest.
Mouse droppings were observed in the bay/loading area in front of the walk-in freezer., , Remove mouse droppings safely and disinfect contaminated areas. Seal possible pest entry points and remove clutter in this area.
The leather chair by the display case was damaged with foam exposed., , Remove this leather chair. A chair that is in good condition and can be easily cleaned can be used.
The bay/loading area had holes in the floor with an accumulation of concrete fragments and splinters., , Repair the floor so that it is smooth, non-absorbent to moisture and easy to clean.
Metal floor-wall joints in the food processing area and walk-in coolers were covered in rust., , Remove rust, repair or replace the metal joints.
1) Shelves in the small walk-in cooler were rusty. , , Repair or replace shelves., , 2) There was a hole under the hand sink located by the display case., , Repair the wall., , 3) Water had accumulated on the damaged flooring located by the band saw., , Repair the floor., , 4) There was a gap between the wall and metal floor-wall joints in the large walk-in cooler., , Seal gaps., , 5) The floor in the back meat processing area was in a state of disrepair. Water had accumulated on uneven surfaces. , , Repair the floor.
There was old food debris in the hard-to-reach areas of the food slicer., , Disassemble equipment to its simplest form. Clean and sanitize all parts properly after use.
1) Water was dripping from the condenser in the small walk-in cooler. The floor was wet., , Repair the walk-in cooler to stop the leak and clean the floor., , 2) The 3-compartment sink for the retail was not usable due to a missing faucet handle. , , Repair the sink., , 3) The door for the walk-in freezer did not seal properly. Water was dripping from a hose outside of this door. Water on the floor had froze. , , The hose was properly turned off during the inspection. Repair the door and remove ice from the floor., , 4) There was a buildup of ice in the corner of the large walk-in cooler., , Remove the source of ice build-up and remove ice from the floor.
3 infractions
Weather stripping on the bay door across the freezer was in disrepair, leaving visible gaps at the bottom of the door., - Please replace/install weather stripping to eliminate the gaps.
***Ongoing Violation***, , The bay/loading area floor surface were cracked., - Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1. Interior metal side-panels at the walk-in cooler door entrance were damaged and broken off, leaving an , exposed gap., - Please repair/replace., , 2. Buildup of ice was noted on the wall corner underneath the fan in the walk-in cooler. The wall-floor joints in walk-in cooler appeared rusty., - Repair the wall floor joints in the walk-in cooler so that they are smooth, impervious to moisture and easily cleanable.
5 infractions
1) The posted closure sign on the front door had been removed., , The closure sign was reposted. Keep the sign visible to the public until permission is given to remove the posted sign., , 2) The facility was operating against a closure order. There was evidence of food preparation. , , Cease all food service operations.
Weather stripping on the bay door across the freezer was in disrepair, leaving visible gaps at the bottom of the door., - Please replace/install weather stripping to eliminate the gaps.
The food establishment was operating without a valid food handling permit., , Obtain a valid food handling permit.
5 infractions
The posted closure sign on the front door had been removed again., , The closure sign was reposted. Keep the sign visible to the public until permission is given to remove the posted sign.
Weather stripping on the bay door across the freezer was in disrepair, leaving visible gaps at the bottom of the door., - Please replace/install weather stripping to eliminate the gaps.
The food establishment was operating without a valid food handling permit., , Obtain a valid food handling permit.
4 infractions
Weather stripping on the bay door across the freezer was in disrepair, leaving visible gaps at the bottom of the door., - Please replace/install weather stripping to eliminate the gaps.
The food establishment was operating without a valid food handling permit., , Obtain a valid food handling permit.
***Ongoing Violation***, , The bay/loading area floor surface were cracked., - Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
6 infractions
Chlorine surface sanitizer initially prepared in the spray bottle was tested at 10 ppm. Operator prepared sanitizer during inspection and concentration was tested at 100 ppm., - As discussed, ensure that sanitizer solution is prepared for use at all times for each food handling area and check sanitizer concentration regularly.
Weather stripping on the bay door across the freezer was in disrepair, leaving visible gaps at the bottom of the door., - Please replace/install weather stripping to eliminate the gaps.
***Ongoing Violation***, , Valid food handling permit was not displayed at the facility. Outstanding balance for permit fee. Facility operating without a valid food handling permit., - Please ensure to pay the permit fee and display FHP at the facility.
3 infractions
Outstanding balance for permit fee. Facility operating without a valid food handling permit.
The bay/loading area floor surface were cracked., , Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1) Boxes of frozen spoiled meat were left at room temp in open bay area for return the next day. Keep product frozen in walk-in freezer to mitigate odour of spoiled meat until ready to be returned the next day., 2) Walk-in freezer was disorganized and open/uncovered boxes of frozen meat to be discarded were stored on top of/among meat for public consumption. Store waste and foods separately.
2 infractions
The bay/loading area floor surface were cracked., , Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1) Boxes of frozen spoiled meat were left at room temp in open bay area for return the next day. Keep product frozen in walk-in freezer to mitigate odour of spoiled meat until ready to be returned the next day., 2) Walk-in freezer was disorganized and open/uncovered boxes of frozen meat to be discarded were stored on top of/among meat for public consumption. Store waste and foods separately.
1 infraction
The bay/loading area floor surface were cracked., , Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
3 infractions
There were no drain plugs available for properly performing manual dishwashing method., Drain plugs/stoppers were obtained while on site.
The bay/loading area floor surface were cracked., , Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
Two metal flashing pieces in the walk-in cooler were missing and the insulation was exposed., , Install the missing metal flashing in the walk-in cooler., Ensure all surfaces are smooth, non-absorbent and easily to clean.
***Ongoing Violation***, , The bay/loading area floor surface were cracked., - Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1. Interior metal side-panels at the walk-in cooler door entrance were damaged and broken off, leaving an , exposed gap., - Please repair/replace., , 2. Buildup of ice was noted on the wall corner underneath the fan in the walk-in cooler. The wall-floor joints in walk-in cooler appeared rusty., - Repair the wall floor joints in the walk-in cooler so that they are smooth, impervious to moisture and easily cleanable.
***Ongoing Violation***, , The bay/loading area floor surface were cracked., - Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1. Interior metal side-panels at the walk-in cooler door entrance were damaged and broken off, leaving an , exposed gap., - Please repair/replace., , 2. Buildup of ice was noted on the wall corner underneath the fan in the walk-in cooler. The wall-floor joints in walk-in cooler appeared rusty., - Repair the wall floor joints in the walk-in cooler so that they are smooth, impervious to moisture and easily cleanable.
1. Interior metal side-panels at the walk-in cooler door entrance were damaged and broken off, leaving an , exposed gap., - Please repair/replace., , 2. Buildup of ice was noted on the wall corner underneath the fan in the walk-in cooler. The wall-floor joints in walk-in cooler appeared rusty., - Repair the wall floor joints in the walk-in cooler so that they are smooth, impervious to moisture and easily cleanable.
***Ongoing Violation***, , The bay/loading area floor surface were cracked., - Finish the bay/loading area floor surface so it can be smooth, non-absorbent and easily to clean.
1. Interior metal side-panels at the walk-in cooler door entrance were damaged and broken off, leaving an , exposed gap., - Please repair/replace., , 2. Buildup of ice was noted on the wall corner underneath the fan in the walk-in cooler. The wall-floor joints in walk-in cooler appeared rusty., - Repair the wall floor joints in the walk-in cooler so that they are smooth, impervious to moisture and easily cleanable.
Cardboard used on metal cart in the walk-in cooler was wet and visibly soiled. Operator removed cardboard during inspection., - Ensure equipment is cleaned and maintained in a sanitary condition at all times., - Ensure that surfaces are smooth, durable, easily cleanable, and impervious to moisture.