299 Erin Woods Drive SE
Not in Compliance
6 violations were found at the most recent inspection.
Source: Alberta Health Services Environmental Public Health
May 29, 2026
Sanitizer solution (bleach) was tested and found to be below the effective concentration of 100 ppm. The solution measured approximately 10 ppm and was discarded during the inspection. Sanitizer solutions must be maintained at adequate concentrations to ensure proper disinfection of food contact surfaces. Inadequate concentrations may allow harmful microorganisms to persist, increasing the risk of foodborne illness., , Ensure sanitizer solutions are prepared and maintained at a minimum concentration of 100 ppm for effective sanitization. Test solutions regularly using appropriate test strips and remake as required to maintain proper concentration.
Cooking temperature guidelines for high-risk foods such as chicken fries are not available. Food safety procedures and monitoring are necessary to ensure foods are cooked to safe temperatures and to prevent the risk of undercooking and foodborne illness., , - Confirm internal temperature for each batch by using a probe thermometer or a timer to ensure food is cooked to the required temperature.
A bleach solution bottle was observed without proper labelling. Bottle was labelled at the time of inspection. Chemicals must be clearly labelled to prevent misuse and accidental contamination of food or food contact surfaces., , Ensure all chemical containers are clearly labelled with their contents at all times. Staff to be reminded periodically of proper labelling requirements.
Mechanical (high temperature) dishwasher was not reaching the required sanitizing temperature of 71°C. The unit was run for three consecutive cycles and measured 65°C, 65°C, and 68°C, respectively. Proper sanitizing temperatures are necessary to effectively eliminate microorganisms on utensils and equipment. Failure to achieve the required temperature may allow microorganisms to survive, resulting in a biological hazard and increasing the risk of contamination of food contact surfaces., , - As an interim measure, use the 2-compartment sink with manual wash-rinse-sanitize method for cleaning food contact utensils. Also, use single-service (to-go) utensils until the mechanical dishwasher is repaired and verified to be operating at required temperature of 71°C. , , - Ensure the dishwasher is serviced or repaired to consistently achieve a minimum sanitizing temperature of 71°C prior to further use.
1. Dishwasher temperature monitoring logs are not being maintained. Routine monitoring ensures the dishwashing process consistently achieves proper sanitizing conditions. Without logs, verification of safe operation is not possible., , - Implement and maintain a temperature log for dishwashing operations. Record temperatures at regular intervals and retain records for verification., , 2. The thermometer available is not suitable for effectively monitoring maximum temperatures achieved during dishwashing cycles. Appropriate thermometers are essential to verify that required sanitizing temperatures are consistently achieved. Without the ability to capture maximum temperatures, inadequate sanitization may go undetected., , - Obtain a probe thermometer capable of recording maximum temperatures to accurately monitor dishwashing performance. Ensure the device is used routinely to verify that required sanitizing temperatures are achieved.
1. Uncovered drain hole connected to the ice machine in the ice room. Uncovered drain openings may allow the entry of pests and contribute to unsanitary conditions. Floors and drainage systems must be maintained in a manner that prevents pest harborage and allows for proper cleaning., , - Ensure the drain opening is properly covered and maintained in good condition to prevent pest entry and support sanitary conditions.
East Calgary Twin Arenas is in the ERIN WOODS neighbourhood. ERIN WOODS, Calgary has 21 restaurants tracked on Pass or Fail, inspected by Alberta Health Services Environmental Public Health. As of June 26, 2026, there are 15 (71%) In Compliance on their most recent inspection, with none Not in Compliance or Closed.
This record comes from Alberta Health Services Environmental Public Health, which inspects food premises across Alberta. Inspectors record any violations of applicable health regulations on each visit. The result above is the most recent inspection on file.
In Compliance means no violations were outstanding at that visit. Not in Compliance means one or more violations were found that weren't corrected on site. Closed means the inspector ordered the premises to stop serving customers until the issues were corrected.
Hope Mission Calgary
DOVER
This restaurant has been inspected 5 times since November 10, 2023, with 1 in compliance, 4 not in compliance, and 0 closures on record.
6 violations
Sanitizer solution (bleach) was tested and found to be below the effective concentration of 100 ppm. The solution measured approximately 10 ppm and was discarded during the inspection. Sanitizer solutions must be maintained at adequate concentrations to ensure proper disinfection of food contact surfaces. Inadequate concentrations may allow harmful microorganisms to persist, increasing the risk of foodborne illness., , Ensure sanitizer solutions are prepared and maintained at a minimum concentration of 100 ppm for effective sanitization. Test solutions regularly using appropriate test strips and remake as required to maintain proper concentration.
Cooking temperature guidelines for high-risk foods such as chicken fries are not available. Food safety procedures and monitoring are necessary to ensure foods are cooked to safe temperatures and to prevent the risk of undercooking and foodborne illness., , - Confirm internal temperature for each batch by using a probe thermometer or a timer to ensure food is cooked to the required temperature.
A bleach solution bottle was observed without proper labelling. Bottle was labelled at the time of inspection. Chemicals must be clearly labelled to prevent misuse and accidental contamination of food or food contact surfaces., , Ensure all chemical containers are clearly labelled with their contents at all times. Staff to be reminded periodically of proper labelling requirements.
Mechanical (high temperature) dishwasher was not reaching the required sanitizing temperature of 71°C. The unit was run for three consecutive cycles and measured 65°C, 65°C, and 68°C, respectively. Proper sanitizing temperatures are necessary to effectively eliminate microorganisms on utensils and equipment. Failure to achieve the required temperature may allow microorganisms to survive, resulting in a biological hazard and increasing the risk of contamination of food contact surfaces., , - As an interim measure, use the 2-compartment sink with manual wash-rinse-sanitize method for cleaning food contact utensils. Also, use single-service (to-go) utensils until the mechanical dishwasher is repaired and verified to be operating at required temperature of 71°C. , , - Ensure the dishwasher is serviced or repaired to consistently achieve a minimum sanitizing temperature of 71°C prior to further use.
1. Dishwasher temperature monitoring logs are not being maintained. Routine monitoring ensures the dishwashing process consistently achieves proper sanitizing conditions. Without logs, verification of safe operation is not possible., , - Implement and maintain a temperature log for dishwashing operations. Record temperatures at regular intervals and retain records for verification., , 2. The thermometer available is not suitable for effectively monitoring maximum temperatures achieved during dishwashing cycles. Appropriate thermometers are essential to verify that required sanitizing temperatures are consistently achieved. Without the ability to capture maximum temperatures, inadequate sanitization may go undetected., , - Obtain a probe thermometer capable of recording maximum temperatures to accurately monitor dishwashing performance. Ensure the device is used routinely to verify that required sanitizing temperatures are achieved.
1. Uncovered drain hole connected to the ice machine in the ice room. Uncovered drain openings may allow the entry of pests and contribute to unsanitary conditions. Floors and drainage systems must be maintained in a manner that prevents pest harborage and allows for proper cleaning., , - Ensure the drain opening is properly covered and maintained in good condition to prevent pest entry and support sanitary conditions.
2 violations
Baseboard was peeling off from wall by the dishwasher and behind the cooking stove. , - Repair the baseboard.
**Violation still exists**, The hard to reach areas behind the equipment and base boards appeared dirty., Clean the hard-to-reach areas thoroughly.
1 violation
The hard to reach areas behind the equipment and base boards appeared dirty., Clean the hard-to-reach areas thoroughly.
No violations
2 violations
A hole was observed in the wall in front of walkin cooler., Ensure to patch the hole so that it is smooth, impervious to moisture and easily cleanable.
The following area requires deep cleaning:, 1. Floors, 2. Area behind the dishwasher and under the two com sinks.